Mounting Flange

$23.00$32.00

Clear
SKU: N/A. Category:

Product Description

Mounting Flange

Surface Mounting Flange – On 12-Volt installations, surface flange must be used with junction box (not included). Neoprene gasket supplied to ensure water tight seal. BR is Cast Natural Brass, BBR is Bronzed Cast Brass.

Finishes for the flange

FOR 12 VOLT INSTALLATION
1) Position surface mounting flange on deck. Mark center of all
four wood screw mounting holes and center hole for power supply
wire to pass through. Drill pilot holes for supplied wood screws
with 1/8” drill. Next drill 3/8” hole to accommodate power supply
cord.
2) Place surface mounting flange over drilled pilot holes. Neoprene
gasket is not to be used. Start each wood screw. Tighten until
secured to deck.
3) Pass fixture lead wires through threaded center hole on top of
flange and through drilled hole in deck. Mount fixture according
to instruction sheets. Make wire connections.
FOR 120VOLT INSTALLATION.
Surface mounting flange must be used with 4” round wiring compartment
(not included). Neoprene gasket is suppled to ensure
watertight seal. Consult qualified electrician regarding deck mounting
and wiring procedures so as to be certain all local requirements
and codes are followed.

Technical Information

Width: 4.5″
Height: 1″
Length: 4.5″
Safety Rated: Not Required
Dual Mount: No
Lamp Included: Not Included
Glass Description: Surface Mounting Plate
Finish: Textured Architectural Bronze

Related Documents:

Instruction Sheet 15601-BL Download
Instruction Sheet 15601-EUR Download
High Res Images 15601 Download

Additional information

Weight N/A
Choose Color

Choose Color, 15601AZT $23, 15601BBR $32, 15601BKT $23, 15601WHT $23